Foret pour insert à enfoncer Keep-nut 12x10

Special Insert Keep-nut Drill Bit 12x10

Special drill bit with a flat tip for drilling holes in hard materials (concrete, Corian, stone, HPL) for use with KEEP-NUT® - Special Insert anchors. Recommended drill speed is 3600 - 6000 RPM. Water cooling is essential for cooling and removing the drilled material. The drilling feed rate (25–30 mm/min) must be adjusted according to the hardness of the material (optimal drilling time per hole is 30 seconds).

Key Features:

• Recommended drill speed is 3600 - 6000 RPM
• Water cooling is essential for cooling and removing the drilled material